机电耦合系数,electromechanical coupling coefficient
1)electromechanical coupling coefficient机电耦合系数
1.0?kV/mm,20?min and 80?℃,respectively,the piezoelectric constant d_(33),the relative dielectric constant ε_r and theelectromechanical coupling coefficient K_p and K_t of the composites all increased with the increase of PLN content.结果表明,在极化工艺参数为:极化电场强度为5 kV/mm;极化时间为20 min;极化温度为80℃的条件下,以硫铝酸钡钙水泥矿物作为基体的压电复合材料的相对介电常数rε和压电应变常数d33随着PLN质量含量的增加非线性增长,其值接近立方体模型理论值,随着PLN质量含量的增加,平面和厚度伸缩机电耦合系数Kp、Kt增大。
2.The results show that the piezoelectric voltage factor g_(33) decreases nonlinearly with the volume fraction of the piezoelectric ceramic phase increasing,but piezoelectric strain factor d_(33),dielectric constant andelectromechanical coupling coefficient K_p and K_t increase.平面和厚度机电耦合系数Kp和Kt及介电常数εr随PMN体积分数的增大而增大,在低频段和高频段,其介电常数随频率的变化较平稳,表现出良好的介电频率稳定性。
3.Crystal orientation dependence of piezoelectric modulus d33 andelectromechanical coupling coefficient k33 have been calculated phenomenologically.探讨了LBO晶体纵向压电系数d33及机电耦合系数k33随空间方向变化的规律,分别得到了LBO晶体压电系数d33及机电耦合系数k33的最大值及其方向,并与Li2B4O7进行了比较。
英文短句/例句
1.The Measurement of the Electromechanical Coupling Coefficient of the Giant Magnetostrictive Material超磁致伸缩材料机电耦合系数的测量
2.ELECTROMECHANICAL COUPLING COEFFICIENT (K_(33)) OF Fe_(72.5)Ga_(27.5)MAGNETOSTRICTIVE ALLOYFe_(72.5)Ga_(27.5)磁致伸缩合金动态机电耦合系数K_(33)
3.It gives the resonance frequency, effective electeromechanical coupling coefficients.本文给出了这种换能器的共振频率、效机电耦合系数及实验结果。
4.Mathematical Model of Coupled Bending and Torsional Vibration of Shaft System of a Generator Set Excited by Electromagnetism;发电机组轴系弯扭耦合电磁激发振动数学模型
5.Study on the Parameter Test System of Permanent-Magnet DC Motor with No-Coupling Method;无耦合永磁直流电机参数测试系统的研究
6.Analysis of Electromechanical Coupling Facts and Decoupling Control Strategies for Complex Electromechanical Systems复杂机电系统机电耦合分析与解耦控制技术
7.Analysis of magneto-mechano-electronic coupling factors in magnetostrictive/piezoelectric laminated composite磁致伸缩/压电叠层复合材料磁-机-电耦合系数分析
8.Study on Parameter Optimization and Dynamic Characteristics of Mechanical-Electrical Coupling of Ultra-High Speed Grinding Motorized Spindle System;超高速磨削电主轴系统机电耦合参数优化及动态特性研究
9.Electromechanical Coupling Modeling and Analyzing of Elevator Door System电梯门系统机电耦合建模与仿真分析
10.Design and Develop of Electromechanical Coupling Integrated Test and Evaluation System机电耦合综合测评系统的设计与开发
11.A DIRECT MODEL OF SRD BY COUPLED FIELD-CIRCUIT开关磁阻电机驱动系统场路直接耦合的数学模型
12.Parameters Identification and Adaptive Synchronization of Uncertain Modified Coupled Dynamos System;不确定变形耦合发电机系统的参数辨识与自适应同步
13.Study on simulation of fluid-solid thermal coupled fields for the ventilation and heat rejection system of hydrogenerator水轮发电机通风散热系统的耦合仿真与参数分析
14.Electromechanical Coupled Dynamics for Electromechanical Integrated Electrostatic Harmonic Micro Drive System;机电集成静电谐波微传动系统机电耦合动力学
15.Electro-mechanical Coupling Simulation of the Complex NC Machine Tool from Milling and Hobbing Based on ITI SimulationX基于ITI SimulationX数控铣滚齿复合机床机电耦合仿真
16.Research on Coupled Flexural and Torsional Vibrations of Turbo-generator Shafts;汽轮发电机组轴系弯扭耦合振动研究
17.Tracking Control of Modified Coupled Dynamos Chaotic System变形耦合发电机混沌系统的追踪控制
18.The polarization coupling term and birefringence coupling term are included in the coupling coefficient expression.耦合系数包括偏振耦合项和双折射耦合项。
相关短句/例句
electromechanical coupling factor机电耦合系数
1.The easier coupling of the thickness fundamental resonance with the higher overtone of low-resonant modes leads to a bad measurement accuracy of the thickness series resonance frequencies or a failure of the resonance frequency measurement,resulting in deteriorating the accuracy and the identity of theelectromechanical coupling factor determined by the traditional overtone ratio method.压电振子低频振动模式的高次泛音易与厚度振动模式的基频相耦合,导致厚度振动的基音串联谐振频率不能精确测量(或无法测量),造成传统泛音比法测定压电振子的机电耦合系数的精度和一致性变差或无法进行测定。
2.006, d33 = 243 pC/N)、highelectromechanical coupling factor k33 (x = 0.006时d33=243pC/N)、低的介质损耗(tanδ<2×10–2)、较高的机电耦合系数(x=0。
3.The new piezoelectric crystal of LGS and it s characteristics are introduced simply in this paper, and the SAW properties of X -cuts, Y -cuts and Z -cuts of LGS are analyzed from theory, the results approved that LGS is a material with highelectromechanical coupling factor and cuts of zero PFA and TCD.简要介绍了硅酸钾镧(LGS)压电晶体及其性能,从理论上分析了其X切、Y切和Z切的声表面波(SAW)特性,证实了LGS具有机电耦合系数高且存在能流角和温度延时系数为零的切向等优点。
3)electromechanical coupling factors机电耦合系数
1.A new type of shear horizontal wave which excited by composing a heavy metal film on an ST cut 90°X propagation(direction perpendicular to X-axis) quartz substrate was analyzed by the methods of elastic wave propagation in thin layers,and the dependence of SAW velocities andelectromechanical coupling factors on normalized thickness of various metal film were acquired.采用层状介质中波的传播分析法对一种在ST-90°X切割的石英基底上覆盖重金属膜激发的一种新型纯剪切(SH)波的传播特性进行了分析,并得到了传播速度、机电耦合系数与金属膜厚和传播方向的关系以及位移分量分布曲线。
2.In this paper,near the morphortropic phase boundary x =0 53,crystal orientation dependence of piezoelectric constants d33 , d31 andelectromechanical coupling factors k 33 ,k31 have been calculated phenomenologically for PZT60/40(60%PbZrO 3,40%PbTiO 3)in three dimensional space by means of transformations.5 3)附近 ,利用坐标变换法 ,对压电性能较好的 PZT6 0 / 40 (6 0 % Pb Zr O3,40 %Pb Ti O3)晶体的压电系数 d33、d31 以及机电耦合系数 k33、k31 的空间分布进行了计算 ,绘制了它们在空间分布的直观图像 ,得到了它们的最大值及其方位 ,其中 d33的最大值为 189p C/ N ,是未变换前的 2 。
4)electro-mechanical coupling coefficient机电耦合系数
1.The effects of the position,the diameter and length of the bolt on the resonance frequency,the anti-resonance frequency and effectiveelectro-mechanical coupling coefficient are studied.考虑到螺栓的影响,把螺栓等效为四端网络计入换能器的机电等效电路,推导了位移节面位于金属块中时压电换能器的频率方程,探究了压电换能器的共振频率、反共振频率和有效机电耦合系数等性能参数随螺栓的几何尺寸和位置的变化规律。
5)magneto-mechano-electronic coupling factor磁-机-电耦合系数
1.Analysis ofmagneto-mechano-electronic coupling factors in magnetostrictive/piezoelectric laminated composite磁致伸缩/压电叠层复合材料磁-机-电耦合系数分析
6)electromechanical coupling coefficient (K_(33))机电耦合系数(K_(33))
延伸阅读
纵向机电耦合系数分子式：CAS号：性质：表示纵向：长度伸缩振子振动时，机械能与电能之间相互转换的能力，通常用K33表示。可用串联谐振频率fr，并联谐振频率fa和泊松比σE的函数表查得。也可由下式计算求得， 。当求得K33后就可作为大致判定该压电材料用于制造相应振动模式的器件是否适用。
